TM072160
Fig.
Replacing the lid and and the screws
4.4.4 Installing the push-button
Do not install the push-button in a
shower or under the tap/faucet where it
could be exposed to water. Mount it at
a suitable height out of reach of small
children and pets.
To install the push-button:
1.
Remove the mounting bracket from the back
of the push-button.
2.
Remove the pull-tab from the end of the AAA
batteries. The push-button will start up.
3.
Use the included double-sided tape to fasten
the mounting bracket to a surface or wall
away from water droplets or splashes.
4.
To pair the push-button with the pump: With
the push-button near the pump, press and
hold the connect button on the pump for 2
seconds. The blue connect symbol will flash.
The connect symbol will stop flashing after 30
seconds if no device has been detected.
5.
Press the button on the push-button for 2
seconds. The blue LED on the push-button
will flash.
6.
After successful pairing of the push-button
and the pump, the blue light will
be on continuously for 5 seconds on both
devices.
7.
If the pairing fails, the light will flash red for 5
seconds on both the pump and the push-
button. Restart installation of the push-button.
8.
To verify operation press button on the push-
button for less than 2 seconds. Check that
the connect symbol on the pump is on and
green for approx. 2 seconds and the pump
turns on.
9.
Replace the push-button on the mounting
bracket.
10. If more than one push-button is used for the
system, repeat the installation procedure.
Pull-tab
Double-sided
tape
TM072154
Fig.
Removing the mounting bracket and
the pull-tab
4.4.5 Installing the repeater
To install the repeater:
1.
Connect the included USB cable to the
repeater.
2.
Connect the other end of the USB cable to
the included power adapter.
3.
Fit the included plug adapter to the power
adapter.
4.
Plug the power adapter into a power outlet to
power on the repeater.
5.
The LED on the repeater will light green to
indicate the repeater is in operation.
4.5 Electrical connection
DANGER
Electric shock
Death or serious personal injury
‐
All electrical work must be carried
out by a qualified electrician in
accordance with the latest edition
of the National Electric Code and
state, local codes and regulations.
DANGER
Electric shock
Death or serious personal injury
‐
Switch off the power supply before
starting any work on the product.
Make sure that the power
supply cannot be switched on
accidentally.
DANGER
Electric shock
Death or serious personal injury
‐
This pump has not been
investigated for use in swimming
pool or marine areas.
9
English (US)
