en-2 English
IMPORTANT NOTICE FOR OPERATORS
No user serviceable parts inside.
Do not remove any outer
surfaces. Do not modify this equipment or remove warning labels.
Modifications can increase risks to the operator. Do not use this
equipment if it is damaged.
Always wear sufficient eye protection. Take steps to avoid dust
inhalation by wearing appropriate respiratory protection.
Do not lift or transport by grasping the drive plate or spindle. Allow
the drive plate and sharpening wheel to come to a complete stop
before:
• grasping the drive plate and / or wheel
• changing the wheel
• grasping or attempting to remove the wheel lock
Plug into grounded outlets only.
Do not use adapters that bypass the
ground plug.
Do not apply excessive or forceful pressure to a tool while using this
unit.
This action may result in damage to the tool, the unit and its
components, and / or the operator.
Tools may become hot while operating this unit as intended.
Protect
skin and surfaces from burns or damage.
Tools can be extremely sharp after this unit is used as intended.
Protect skin and surfaces from punctures, cuts, or damage.
Do not attempt to operate this unit in any position other than upright
as shown with the Front View in FIG. 1 on page 3.
The proper use of this equipment does not generate noise above
70dB(A).
FOR URGENT SITUATIONS, STOP THE UNIT IMMEDIATELY BY:
• Powering off the unit with the power switch button
• Setting the reversing rocker switch to the center “off” position
• Disconnect the 24-volt power converter from the back of the unit
• Disconnect the 24-volt power converter from the electrical power source
•
Included 24-volt power converter connected to a
properly grounded electrical power outlet.
USE ONLY THE SUPPLIED 24-VOLT POWER CONVERTER.
The included
power converter may be connected to any properly grounded single-
phase source of AC power within a voltage range of 100 to 240 V, 50
or 60 Hz. The power converter must be used with a suitable grounded
electrical system. Using it with an ungrounded system could expose
the equipment to electrical damage. Do not use older generation power
converters. If a replacement is needed, contact GRS or an authorized
GRS dealer.
•
A sturdy surface with adequate lighting.
Make use of a heavy workbench or suitable solid furniture to support
this equipment, workpiece, and any additional equipment and supplies.
Adequate lighting allows clear sight, and may help prevent accidents
and reduce fatigue.
•
Respiratory protection appropriate for the
material being ground.
The dust created while sharpening some tool materials may present a
health risk.
• Eye protection.
REQUIRED EQUIPMENT
Read this manual entirely before connecting to power source.
Damage not covered by the warranty may result from not following the instructions and maintenance in this manual.
