PAGE 2 of 2
LIT-003-168
GRS Positioning Vise
Complete Assembly #003-541
PART
# DESCRIPTION
1 003-064 Thread Pin, Left Hand
2 003-007 Jaw Screw
3 003-009 Jaw, Right Hand
4 003-065 Thread Pin, Right Hand
5 003-008 Jaw, Left Hand
6 002-450 Bearing 5/16" Steel Ball
7 003-142 Vise Crown S.S.
8 003-151 Spring
9 003-206 Shim Washer
10 003-207 Lock Button
11 003-540 Handle Assembly
12 003-148 Mounting Plate
13 002-067 #10-32 x 1/2" SHCS
14 022-171 Thrust Washer-.078 THK
15 022-149 Bearing
16 022-150 Race-.031 THK
17 003-143 Spacer, Drag Pin
18 002-212 Bearing, 5/8" x 1/2"
19 002-214 Washer, 0.312 x 0.859 x 0.125
20 002-112 5/16"-18 x 3/4" HHB
21 003-144 Drag Pin
22 003-020 Spring, Block Drag
23 003-067 1/2"-13 x 1/2" SSS FLT PT HF
24 003-141 Base-Positioning Vise
25 002-209 Nylon Fasteners
26 003-506 Tire Assembly
27 002-127 O-Ring, 0.625 x 0.75 x .062
28 003-507 Pin Plate Assembly (2 Pin)
29 003-508 Pin Plate Assembly (1 Pin)
30 003-015 Pin, 1/4"
31 003-016 Pin, 3/8"
32 002-091 Wrench 1/4" T Handle Allen
33 002-174 Roll Pin, 1/8" x 3/4"
34 003-538 Post
35 003-146 Yoke
36 003-661 1/4" Hex Drive Knob
900 Overlander Road • Emporia, KS 66801 USA
800-835-3519 • 620-343-1084 • Fax: 620-343-9640
[email protected] • www.grstools.com
Last Updated: 2014-10-25
Vise Jaw Thread Replacement • #003-627 & #003-628
Overtightening the jaws will cause wear and damage to the threads. If jaws
become loose, replace with kit #003-627. Remove the jaws by opening
them as wide as possible until they come off the end of the jaw screw
(FIG. 8). The jaw thread pin is located on the underside of each jaw.
NOTE: Before removing pins, locate the one with the “L”. This is the left
hand thread pin and will need to be replaced with the same. Apply a small
amount of synthetic grease (included in kit) to the O-rings and jaw screw
before installing them. Lift the jaw screw out of the yoke and replace it.
Note which side the left hand thread is on. Grease the threads and yoke
well.
Start the jaw threads at the same time when replacing them (FIG. 9). Hold
each jaw in position and turn the jaw screw to close them. Either a large
rubber band or a second person is useful to hold the jaws against the
thread while the jaw screw is turned. If the jaws don’t meet at the same
time in the center, remove them and try starting the threads at the same
time again.
FIG. 8
“L” For Left
Hand Thread
Jaw Thread Pin
one located in each jaw
Jaw Screw
Jaw
FIG. 9
