ASSEMBLY INSTRUCTIONS
1. Open the Box in which the unit comes safely packed & remove
all parts. Be careful as some parts are small & maybe left un
noticed
2. Slide the 2 Rubber
Wheels onto the
Rear Wheel Shaft
at the bottom of the
tank. Now slide the
steel washer. Use a
circlip plier to install
the circlip. Repeat
the same for the
2nd wheel
3. Assemble the
Handle using a hex
key & position it as
required using the 2
hex bolts
4. The Tank is now ready & fully mobile
5. Take PTFE tape & apply it onto the threaded end of the drain
tube
6. Apply PTFE tape onto the threaded end of the Collar that fits
into the brass ball valve on top of the tank
7. Assemble the Collar
onto the Brass Valve
on top of the tank &
hand tighten
8. Fasten the threaded
end of the Drain Tube
into the bowl & hand
tighten
9. Open the Tank Closure
valve & now slide the
Drain tube fitted with
the Bowl through it
10. Adjust height as
per need & lock it in
place using the bowl
adjustment tube lock
