15
Flow Rate
Up to 14 LPM (3.70 GPM)
Working Pressure
2-10 BAR (30-150 PSI)
Maximum Air Inlet Pressure
10 BAR (150 PSI)
Maximum Media Outlet Pressure
30 BAR (450 PSI)
Air Inlet Connection
1/4” (F)
Pump Inlet on Stub Pumps only
1” (F)
Pump Outlet Connection
1/2” (F)
Air Consumption
230 LPM (61 GPM)
Noise Level
81 db
SPECIFICATIONS
*
* Pump is available in three different sizes - Stub, 16 Gal & 55 Gal version
•
Always wear protection gear like safety goggles, gloves, apron,
and ear plugs while operating the pump
•
Never let any body part come in front of, or in contact with the
control outlet
•
Always cut off air supply after use, so that media cannot leak in
case any of the pump component fails
•
Before switching the air supply on, check hoses for any sign of
wear, leak or loose fittings. Replace as necessary
•
Do not smoke near the pump. Do not use the pump near a source
of spark / open flames
•
When changing the working fluid, at least 1 litre of new fluid
should be discarded to avoid mixing of fluids
•
Pump should NOT be operated for more than 4 hrs continuously
•
Pump must be supplied with CLEAN & DRY compressed air via an
FRL unit
•
Before attempting any maintenance or repair of this product,
disconnect air supply and then operate dispensing gun to release
fluid pressure
•
Use only genuine factory parts for repair
WETTED COMPONENTS
Steel, Brass, Aluminum, Hi Nitrile Rubber, Polyurethane, Turcite
RECOMMENDED USE
ATF, Engine Oil, Gear Oil, Hydraulic Oil, Medium to high viscosity
oils (up to SAE 130), Diesel, Kerosene
DO NOT USE WITH
Corrosive Fluids, Solvents, Acid, Alkalis, Antifreeze, waste oil or
any other media not compatible with the pump components
Table 5
