4
PRIMING INSTRUCTIONS
MAINTENANCE
1. After cartridge or bulk loading of the grease gun, carefully
release plunger handle from the slot in the end cap (In case of
Filler Pump Loading, plunger rod is already free from the slot).
2. Engage plunger rod with the follower by rotating the plunger
handle. Move plunger rod back and forth into the grease
barrel to force out any trapped air.
3. Disengage plunger rod from the follower by rotating the
plunger handle. Push the plunger rod into the grease barrel.
Wipe the Automatic Air Bleeder to make it free of any
blockage or debris.
4. Press the grease gun switch until the gun starts dispensing
grease.
1. BEFORE PERFORMING ANY MAINTENANCE OR WHEN
STORING THE GREASE GUN, ensure the Switch is in the
”OFF” position, Battery is removed from the Grease Gun and
the Charger is unplugged from its electrical outlet.
2. BEFORE EACH USE, check for misalignment, damage, noise
or binding of moving parts, leaking Battery Pack, damaged
Hose, and any other hazardous condition.
3. Do not use a defective equipment unless the fault is rectified.
4. Never burn Batteries, as they can explode in a fire. Do not
charge leaking Batteries. Contact local solid waste authorities
for instructions on correct disposal or recycling of the Battery
Pack.
5. Use a soft, dry cloth, remove all dirt, grease, and debris from
the exterior of the Grease Gun. Do not use solvents to clean
the Grease Gun.
6. Keep the Grease Gun and its accessories in a clean, dry
location and out of children reach
GREASING A GREASE FITTING / GREASE NIPPLE
1. The grease coupler provided at the end of the grease gun
hose has a jaw type construction. The coupler jaws will snap
on to a grease fitting and maintain a tight fit.
2. When connecting the coupler to the grease fitting, press the
coupler straight onto the grease fitting to form a snug fit.
Start operating the grease gun with the coupler as square to
the grease fitting as possible.
3. Once greasing is completed, slightly tilt the coupler, twist and
pull back. The tilt and twist action will allow easy removal of
the coupler from the grease fitting.
To engage,
push straight on
To remove,
Tilt, Twist & Pull
PROBLEM
CAUSE
SOLUTION
Grease leaking form
pressure release Valve
1. Back Pressure more than 6,000 PSI
1. Do not use gun for this application
Grease gun not working
1. Battery not charged
2. Battery not installed properly
1. Charge the battery and then use
2. Take out battery and reinstall correctly
Battery not charging
1. Battery charger not connected to Power Source
2. Battery not fixed properly in the charger
1. Connect battery charger properly
2. Take out battery from the charger and fix again
TROUBLESHOOTING
