37
GROWSPAN
™
GOTHIC PRO GREENHOUSES AND SYSTEMS
Revision date: 05.29.19
ATTACH CONDUIT TO ROLL-UP SIDE COVER
Gather the parts:
• Assembled conduits
• Fabric clips #CC6212 (Divide quantity in half.)
• Tek screws (#FA4482B)
To this point, the roll-up panels along both sides are
secured to and hanging down from the double U-Channel.
1. Unfold the remaining portion of the roll-up cover (if
needed) and evenly stretch it out on the ground along
the frame.
2. Working from the inside the frame
, roll the assembled
cover conduit onto the edge of the cover.
3. Verify that the cover and conduit are evenly positioned
and tuck the cover edge under the conduit and begin to
turn the conduit in a clockwise direction.
NOTE:
If the conduit begins to turn inside the cover
material and is unable to roll up the side evenly, secure
the cover material to the conduit with Tek screws and
fabric clips evenly spaced along the conduit.
4. Continue to roll the conduit until the excess cover
material is wound around the conduit.
5. Repeat these steps for the other side of the shelter.
6. With the excess cover material rolled up on the conduit
assemblies, continue with the
Twist-of-the-Wrist
Assembly
procedure.
Inside View
Diagram shows a different model and is used for illustration
purposes only.
Threaded Rod
Purlin
End
Rafter
Guide
Channel
Carriage
Bolt
Roll-up Side
Conduit
Bottom Purlin
TWIST-OF-THE-WRIST ASSEMBLY
Gather the parts:
• Aluminum channel
• Drive handle
• Gearbox and gearbox drive
• Mounting plate
• Bearing and threaded rod
• 3/8" nuts and washers
The Twist-of-the-Wrist Assembly is designed to roll up a
portion of the sides of the structure. The following steps
describe the assembly and its installation.
1. Measure 1/2" in from the end of the cover conduit,
center-punch the location, and drill a 5/16" hole through
the cover conduit.
2. Insert a tubing adapter into the conduit and align
the holes of the adapter with the drilled holes in the
conduit.
