43
GROWSPAN
™
GOTHIC PREMIUM HIGH TUNNELS
Revision date: 01.08.21 108179_80_81_82_83_84H
INSTALL ROLL-UP END PANEL ROPES
The roll-up panel ropes lace through the roll-up panel.
These ropes wrap around hook lags that are screwed into
the sides of the door frame. Ropes help to keep the roll-
up panel in place when it is fully or partially closed. These
steps describe one way to lace the roll-up panel.
Gather the parts:
• Hook lags (FAX120) — Wood door frame only.
• Rope (CC5525)
• Zipper extension pole (CC2235)
ATTENTION: SKIP TO STEP 3 IF THE STEEL
HEADER KIT WAS PURCHASED AND INSTALLED.
1. Beginning on the
outside of a door frame
, attach a
hook lag between the first two grommet holes below
the bracket. Position the open end of the hook lag
towards the end panel.
IMPORTANT:
Screw the hook lags into the sides of the
door frame, not the front.
Do not screw into the roll-up
panel.
2. Install a hook lag at every other grommet interval as
shown in the diagram below. Use five (5) hooks for
each side.
TOP VIEW
Photo shows the open end of the hook lag
facing the end panels.
Door Frame
3. Tie a length of rope to the first grommet hole below the
guide post bracket, loop it around the first hook lag,
and lace it back through the next grommet. Repeat this
process until the rope is through the last grommet.
4. Leaving some slack, loosely tie the rope off at the
bottom grommet hole.
5. Repeat steps as needed for the other side of the door
frame.
6. Once the ropes on both sides are laced and hooked
in the correct position, untie the rope at the bottom
grommet holes, pull tight to remove excess slack, and
tie off at the bottom grommet holes.
7. Repeat for the remaining end.
NOTE:
Use the included zipper extension pole
(CC2235) to unhook the rope to open the roll-up panel.
The pole can also be used to loop the rope back onto
the hook lags when the roll-up panel is closed.
8. Continue as directed on the next page.
Roll-up
Panel
Grommet
Cover is not shown.
Cover is not shown.
Roll-up
Panel
Tie rope tight to the
first grommet hole
below the bracket.
Dashed line shows the
rope laced behind the roll-
up panel.
