21
Revision date: 08.27.19 113469_70_71HBC
Top Center
A
A
B
B
C
C
D
D
36"
12"
12"
End Rafter Layout
9
Hook & Loop Fastener Installation
Gather parts:
• FA4110 hook fastener strip
• FA4115 loop fastener strip
• 101616 clear super tape
Attach hook & loop fasteners to help secure cover when it is closed. Install in areas noted below.
Use these basic steps to apply hook & loop fastening material:
1. Fully open cover on both sides of frame and lock in position.
2. Use end rafter diagram above and all diagrams
on next page
to
determine fastener locations.
3. Depending on fastener location, clean rafter (or end panel). Attach a
6" section of hook (FA4110) in a location (A - D).
4. Attach 6" section of loop (FA4115) to hook attached in previous step.
Adhesive side loop section with protective film should face up.
5. Verify loop section is square on hook material and remove protective
film to expose adhesive on loop.
6. Take an 8" piece of 101616 tape and attach the
non-adhesive side
of the tape
to loop adhesive.
7. Repeat Steps 3-6 to apply hook & hoop fastener in
all remaining
locations on frame
.
8. Beginning with one side, roll cover down to stabilizer bar and lock
cover into place.
9. Verify cover is positioned as desired on frame.
HOOK & LOOP LOCATION GUIDE–END RAFTERS
•
Position A: Approx. 12" from rafter splice.
•
Positon B: Approx. 36" from top, center of rafter.
•
Positions C & D: Evenly spaced between A & B.
10. Move to one end rafter, carefully lift cover at a hook & loop fastener, and
remove protective strip to expose adhesive surface on tape.
11. Press cover down so adhesive sticks to underside of cover. Work all air
bubbles from between tape and cover.
12. Repeat steps to attach all remaining hook & loop fasteners to the
underside of cover.
13. Repeat Steps 8-12 for remaining side of frame.
14. Finally, carefully roll one cover up to first set of hook & loop fasteners
and press on tape to ensure all mid rafter fasteners are tight to cover.
15. Repeat previous step for all remaining mid rafter fasteners on each side
of frame then test by opening and closing covers a few times.
Clear tape sticks to cover.
Loop fastener sticks to tape.
Hook fastener sticks to rafter.
HOOK & LOOP FASTENER INSTALLATION
