GARDEN GROW • Setup:
1. Main unit
2. Inlet tubing with garden hose
connector
3. Sediment filter
4. Green coconut carbon filter
5. Outlet tubing
6. Garden hose connector
NOTE:
A flow restrictor is built into
thebrass connecting fitting between the two
housings. This gives optimum contact time
for maximum contaminant removal.
Before Installation/Precaution!
*Note:
Do not install the system where the incoming water pressure may
be more than 90psi (6 k/cm2). If unsure, check the pressure with a pressure
gauge, available at your local hardware store. If your water pressure is
more than 90psi (6 k/cm2) install a pressure regulator, available at your
Grow Max Water dealer or hardware store. Do not use with hot water.
How to install the GARDEN GROW unit:
1.
Begin by connecting the garden hose adaptor to your garden hose
or garden tap.
2.
Then take a length of 3/8" tubing (cut your desired amount) and push
one end into the the garden hose adaptor and the other end into the
"feed" inlet port of the filter system on the right side.
3.
Then take another length of 3/8" tubing (cut your desired amount) and
push one end into the other garden hose adaptor and the other end
into the "outlet" port on the left side of the Garden Grow filter system.
4.
You can now connect up your garden hose to the outlet Garden hose
quick connect or you can just use the 3/8” tubing for direct watering.
5.
Before using the system you will need to flush out any carbon fines
and particulates. You simply open the water and flush out the system
for 5 minutes letting the water go to the drain.
You are now ready to use your system!
1
2
3
4
5
6
