Page 1 of 4
growerssolution.com
931-528-3390
SUPER-DUTY GREENHOUSE INSTALLATION
!!!! CAUTION: Tubing ends may be sharp!!!
Read directions completely before beginning assembly.
We recommend that you visit The Learning Center at
, click on How to Assemble under categories. In this section you will find video tutorials
to assist you with the assembly of your new greenhouse. If you have ANY questions please give us a call at
866-928-3390.
Step 1 – Ground Stakes
Square the corner stakes with each other. Take all
measurements on the outer edge of pipe.
Drive Corner stakes and then drive rest of stakes
4 ft.
centers
(Fig 1.1).
NOTE:
Use a large bolt and washer, or 2 x 4 on top of stakes
to drive them into the ground.
The stakes should be approximately 24” below the
ground. The section above ground will be the height of
your sidewall (Fig. 1.2)
About 7 ½ ft for High side, YOU MAY NEED TO CUT DOWN.
NOTE:
Use a string level to keep ground stakes level.
Fig 1.1 Ground Stakes
Fig 1.2 Ground Stake Depth
Step 2 – Bow Assembly
Place bow sections on flat ground.
Slide sections together, and secure at joints with
self-tapping
screws (provided).
Measure up each end of bow 6” and make a reference
mark. The mark is how far the bow goes into the
ground stake (Quonset Style Bow). High Side and Low
Side insert till they stop at a sharp bend. Secure with
tek screw.
NOTE:
Bows are 2 or 3 pieces depending on your
greenhouses’ size.
Fig 2.1 Bow Assembly
