3.1.4 Crimp the below shown insulated ferrule or ring terminals on the end of the AC input
wires. Connect the wires into the terminal block of the charge point as below. Check the
wiring and then close the RCBO in the side window. Close the side window with the cover,
then the wring is done.
3.2 Mount on a pole
3.2.1 Open the package of the pole, take out the pole and mounting accessories.
3.2.2 The pole must be installed on a hard surface, concrete surface is recommended, it can
also be mounted on a solid ground. Drill hols according to the requirements marked on the
illustration for fixing expansion bolts.
3.2.3 Fix the pole onto the holes with expansion bolts. The input cables shall go into the pole
from the bottom middle area and come out of it from the area below the cable hooker.
3.1.3 Put the charge point onto the bracket, and fix it with the 2 screws at the bottom of the
charge point. The installation is done.
5
6
Terminal
Wire
Model
L1/L2/L3/N
PE
11K
22K
44K
11K
22K
44K
2
≧
2.5mm
≧
AWG12
2
≧
2.5mm
≧
AWG12
2
≧
6mm
≧
AWG9
2
≧
6mm
≧
AWG9
2
≧
16mm
≧
AWG5
2
≧
16mm
≧
AWG5
