LIVERPOOL Tube Compressor
Page 12
The track can then be stopped, moved back to the beginning of the track
and playback started again. Once the initial attack of the first note has
been processed, the compressor can be switched out of Hold and put back
to the desired Recovery setting.
2
. If the unit is compressing a track with room ambience, the
ambient noise from the recording would swell up in volume at the end of
the performance as the gain reduction returned from the compressed
level to zero. This can be avoided by switching the Recovery control to an
adjacent Hold position after the last note has finished, which would stop
the compressor release from taking place.
5. Output Attenuator:
The output attenuator is a six position rotary switch. This method of
attenuation allows for constant impedance on the output transformer as
well as the load. The attenuator gives you output gain control of your
signal output into the next device in the chain. The selections are: 0dB, 5
dB, 10dB, 15dB, 20dB and 30dB of precise output signal attenuation.
6. Mains Power Switch
The power switch is used to turn the compressor on or off.