6
No Loader Bracket Installation
16.
Use three 16mm x 2.00mm x 50mm bolts
(PN: 16-1620050) with three washers (1)
(PN: 57-20746) to attach the right support bracket
along with the spacer to the tractor. Use one
16mm x 2.00mm x 50mm bolt with NO washer (2) to
attach the valve mount bracket along with the right
support bracket and chain hook. This is attached at
the top right hole.
17.
Attach the left support bracket (PN: 18-11332)
on the left side of the tractor with four
16mm x 2.00mm x 50mm bolts (PN: 16-1620050)
and four washers (PN: 57-20746).
1
2
14.
Remove and discard factory bolts
from the spacer located on the right side
of tractor.
2
1
15.
Install the right support and valve
mount brackets. The spacer goes on
first, then the right support bracket (2)
(PN: 18-11333), and finally the valve
mount bracket (3) (PN: 18-11453).
3
NOTE:
If a chain hook is present, rotate
chain hook 180º so that the slot is up
instead of down (1). The chain hook may
hit the belly blade assembly if not turned
up.
12.
Rotate the chain hook 180º so that the slot is up instead
of down (1). The chain hook may hit the Belly Blade assembly
if not turned up.
13.
Reinstall the front loader mount.
1
NOTE:
Continue Installation on Page 8 with Step #22.
