2
Rain Cover And Hardware Kit Are Not Shown
Figure 1 - Contents of Box
Figure 2
Figure 3
Figure 4
Hopper Assembly Not
Shown for Clarity
Step D:
Place Control Plate
Assembly Over End of
Lower Linkage as Shown
in Inset
opposite view,
assembled
Screen
Control Handle Assembly
Linkage Plate Assembly
Handle
Assembly
Upper
Linkage
Lower Linkage
Preassembled
Spreader
Rear Deflector Assembly
Step B: Slide
Handle Onto Frame
And Line Up Holes
TOOLS NEEDED FOR ASSEMBLY
• (2) 10mm Wrenches
• (2) 1/2 in Wrenches
Contents of Box – Figure 1
Check contents of box against the parts list to make sure all
components are included. When ordering replacement or spare
parts refer to the parts list for part numbers.
Fig. 4
C.
Carefully insert the Lower Linkage into the Restrictor Plate
underneath the Hopper as shown. (The Lower Linkage has two
bent ends & the Upper Linkage has one threaded end).
Rain Cover And Hardware Kit Are Not Shown
Figure 1 - Contents of Box
Screen
Control Handle Assembly
Linkage Plate Assembly
Handle
Assembly
Upper
Linkage
Lower Linkage
Preassembled
Spreader
Rear Deflector Assembly
Attaching the Handle, Linkage Plate Assembly,
and Lower Linkage – Figures 2 – 5
A.
Remove contents from box and place the preassembled
portion of the spreader upright on its wheels
B.
Slide the Handle onto the spreader frame & line up the holes
Rain Cover And Hardware Kit Are Not Shown
Figure 1 - Contents of Box
Figure 2
Figure 3
Figure 4
Hopper Assembly Not
Shown for Clarity
Step D:
Place Control Plate
Assembly Over End of
Lower Linkage as Shown
in Inset
opposite view,
assembled
Screen
Control Handle Assembly
Linkage Plate Assembly
Handle
Assembly
Upper
Linkage
Lower Linkage
Preassembled
Spreader
Rear Deflector Assembly
Step B: Slide
Handle Onto Frame
And Line Up Holes
Fig. 2
Fig. 1
Rain Cover And Hardware Kit Are Not Shown
Figure 1 - Contents of Box
Figure 2
Figure 3
Figure 4
Hopper Assembly Not
Shown for Clarity
Step D:
Place Control Plate
Assembly Over End of
Lower Linkage as Shown
in Inset
opposite view,
assembled
Screen
Control Handle Assembly
Linkage Plate Assembly
Handle
Assembly
Upper
Linkage
Lower Linkage
Preassembled
Spreader
Rear Deflector Assembly
Step B: Slide
Handle Onto Frame
And Line Up Holes
Fig. 3
D.
Insert the other end of the Lower Linkage into the front hole
on the Linkage Plate Assembly
E.
Attach the Linkage Plate Assembly and Handle to the Frame
using two M6x40 bolts as shown (see Fig. 5 on next page).
Figure 6 shows the lower linkage assembled (for reference).
NOTE:
The Lower Linkage must be attached to the restrictor
and the Linkage Plate Assembly before the Assembly is
attached to the frame. If the Linkage Plate Assembly is attached
to the Frame without the Lower Linkage, the Lower Linkage will
be very difficult to assemble and may cause the restrictor plate
to be broken during assembly
