Toughsat
Flyaway Bracketing Manual
Ground Control
Step 5 – There are four U-Bolts in the hardware pouch. Remove the nuts, washers & spacers from one of the U-
Bolts and insert the U-bolt under a roof-rack rail into any of the bottom bracketing rail holes. (See red arrow above)
Step 6 – On top, slip the washers first over the U-bolt, then the spacer, and then the nut. Use a ratchet wrench to
tighten the U-bolt into place. Repeat this step for the three other U-bolts to secure the bracket to the roof rack.
Step 7 – The leveling posts at the end of the rails should be raised up and tightened so they do not lower. You
have the option of removing the leveling posts entirely by loosening a tightening nut (right image arrow) below the
handle. Once the handle is removed, you may screw the long bolt down and out of the T-Nut.
- 9 -
