ETAGENPLATTE
BELL BUTTON
ETA S 10x, 20x, 30x, 40x
Installationsanleitung
Installation Instructions
Montage / Mounting
1
2
3
4
5
6
7
Darstellung der Form abweichend je Typ
figure of shape varies depending on type
1. Hold stainless steel plate (2) to the wall and straighten it. Mark the holes for fixation and
for push button space (area A, right figure).
2. Drill the holes and put dowels (enclosure) inside. Make sure that there is an adequate space for
push button and wiring inside the wall. (see figure, area A).
3. Detach protection film from the stainless steel plate (2) and feed in the wiring through the
rubber sponge (1) and the stainless steel plate (2).
5. Set the rubber sponge (1) between wall and stainless plate (2) straighten the plate and fix it
with the dedicated srews (enclosure)
6. Detach the protection foil from acrylate-plate (3) and stainless faceplate (4).
7. Mount PROTACT- push button (5) with knurles nut into the faceplate (4).
8. Feed the wiring through the acrylate-plate and connect them to the push button.
(
It is
essentially to see PROTACT - manual !
)
9. Mount the acrylate-plate (3) and the faceplate (4) incl. PROTACT on the stainless plate (2)
and straighten them. Stow away wiring while doing it (area A ).
10. Fix the faceplate (4) with countersunk socketsrew (7) and allen wrench on the stailess plate (2).
ATTENTION !:
At the versions ETA S xx2 (stainless steel) is the acrylate-plate (3) not applicable.
PLEASE FOLLOW CARE INSTRUCTIONS FOR STAINLESS STEEL PARTS !
A
MV 014800 / 08-2014
Grothe GmbH
Löhestraße 22
53773 Hennef
GERMANY
Telefon: (0 22 42) 88 90-0
Telefax: (0 22 42) 88 90-36
E-mail: [email protected]
Internet: www.grothe.de
International:
Fax: +49 22 42 / 88 90-35
E-mail: [email protected]
