1. Using the gasket as a template, mark the mounting holes.
2. Drill 7/32" holes in the marked locations.
3. If you will need wire hole, use a 10mm bit and install the wire grommet into that hole.
4. Secure the light as shown to the left, using the enclosed hardware.
5. Route the wires and connect them using the two butt splices provided.
1.
Connect the Red wire through your switch to a 12-72 VDC power source using a 5 amp fuse.
2.
Connect the Black wire to a Good Chassis Ground.
Permanent Mounting
Wiring
All of our DC powered warning lights are polarity sensitive. These lights are polarity protected
only if the appropriate fuse
is used. All
wires connected to the positive terminal of the battery should be fused at the battery for their rated load.
Testing the light before this
fuse is properly installed will void the warranty on the light.
CAUTION !!
To change patterns,
turn the power off
, remove the dome, and adjust the
jumper accordingly.
No Jumper = Single Flash
Jumper on Pins 1 and 2 = Double Flash
Jumper on Pins 2 and 3 = Quad Flash
Pattern Programming
Check out the collection of emergency and warning lighting we offer.