17
WORK PREPARATION:
Work tool mounting/dismounting
1.
Make sure that the tool is unplugged from the power source
2.
Check if the chuck (1) or (2) is well maintained: if it is clean and greased. If not, clean it and
grease it (you can use e.g. machine grease)
3.
Open the jaws using the opening/closing rings which are the construction elements of the
chuck.
4.
Slide the work tool into the chuck and mount it by closing the jaws (thighten them with a key
or rings).
5.
In order to dismount the work tool repeat the steps 3-5 and remove the work tool from the
chuck.
Gear shift
The device enables preliminary setting of rotation speed. To select a gear use the shift (3). If set to
position 1 the engine rotates with the maximum speed: 400 rpm, in position 2 the maximum speed is
1400 rpm.
Do not drive with the gear ‘2’ and do not drill with the gear ‘1’. It can cause damage to the machine!
Rotation regulation and reversing of the work tool rotation
The tool enables RPM regulation and reversing of the work tool rotation. The regulator serves also the
ON/OFF switch (4). The RPM changes with the level of pressure applied to the switch. To reverse the
rotation, use switch (5).
Battery Mounting/Dismounting
To dismount the battery:
1.
Press the Battery Lock button (7).
2.
Remove the battery (8) from the machine
3.
To mount the battery, slide it into the socket until the lock button (7) clicks
The device is provided with battery life indicator (11) placed next to the rotation reversing switch (5).
Indicator information:
1.
First LED is red: charge the battery
2.
First LED is green: battery charge is at 30%
3.
Two LEDs are green: battery charge is at 60%
4.
All LEDs are green: battery is fully charged
Battery charging
The charger is fi tted for use with AC 100 – 240 V 50 Hz.
The right temperature of the operating battery is from 10 to 40°C. Batteries with a temperature lower
or higher than the specifi ed range will not be charged. They should be previously cooled down or
warmed up to the right temperature.
Wiertarko-wkretarka_GD18Li_Full_v04_HR.indd 17
Wiertarko-wkretarka_GD18Li_Full_v04_HR.indd 17
2016-10-19 03:49:42
2016-10-19 03:49:42