How to Use
19
Auto Flush Function
Flushes the toilet automatically. You can change the flush delay setting.
1. Press the
(set/next) button repeatedly until the [SETTTING 1] screen appears.
2. Press the button below [AUTO FLUSH] repeatedly to select the setting.
[2 sec]: Flushes after 2 seconds
[6 sec]: Flushes after 6 seconds (Default)
[10 sec]: Flushes after 10 seconds
[15 sec]: Flushes after 15 seconds
[OFF]: Auto flush function is off
HINT
• In the case of a power outage or water failure, flush the toilet following the procedure in
“Flushing the Toilet in the Case of
Power Outage or Water Failure” (page 38)
.
• When too much toilet paper is used, it may not be flushed completely when the
(flush/light) button is used. In this
case, press the
(flush/full) button.
• If flushing twice without pause, the toilet may be unable to flush. If this happens, flush the toilet manually by pressing the
/
buttons after a while.
• The auto flush function will not activate when the user sits on the toilet for less than 10 seconds.
SETTING 1
6SEC
AUTO OPEN
/CLOSE
MUSIC
ONLY LID
AUTO
FLUSH
AUTO
MUSIC
1 MUSIC
REPEAT
2
1
