1
GB
Type approvals
The GROHE Red boiling water storage heater with a filter
system must be installed with the safety assembly provided
and must only be used with this in India.
The boiling water storage heater with filter system may only
be operated together with an original GROHE Red boiling
water fitting.
Application
The GROHE Red boiling water fitting supplies boiling water
in addition to hot and cold tap water. Boiling and mixed water
flows into the GROHE Red fitting through separate pipes and
flows out through two separate areas of the flow straightener.
The boiling water storage heater is designed to heat and store
drinking water in pressurised systems.
The boiling water storage heater is suitable for connection to a
mains system with a maximum water pressure of 0.8 MPa.
It must
not
be connected to hot water.
The filter system measures the flow rate using a sensor and
from this calculates the remaining capacity of the filter cartridge
as a function of the set litre capacity. If the filter cartridge litre
capacity set on the display unit is exceeded, the values are
displayed as negative values.
The water filtrate is classified as Category 2 according
to EN 1717.
Safety notes
GROHE Red boiling water storage heater:
This device is
not
intended for use
by persons (including children) with
physical, sensory or mental impairments
or a lack of experience or knowledge
in using devices of this type.
Children must be supervised to ensure
that they do not play with the device.
Danger due to electric shock. Avoid
damaged power supply cables. In the
case of damage, the boiling water
storage heater must be replaced by the
manufacturer or its customer service
department or an equally qualified person.
Caution: Risk of scalding.
Escaping
water is boiling hot.
Never touch the end
of the spout
in order to swivel the spout
as it becomes extremely hot.
• The boiling water storage heater must be connected to
a permanent power supply with earth wire.
• Installation may only be performed in frost-free rooms.
• The boiling water storage heater is only suitable for indoor use.
• The boiling water storage heater must be placed in an
upright position.
• The boiling water storage heater and plug must
not
be
directly or indirectly sprayed with water when cleaning.
• The boiling water storage heater must not be opened.
• Use
only genuine replacement parts and accessories
.
The use of other parts will result in voiding of the warranty
and the CE identification, and could lead to injuries.
If the boiling water storage heater is to be drained, the safety
assembly of the boiling water storage heater must be removed.
Invert the boiling water storage heater and allow the water to
run out.
However, we strongly advise against draining the boiling
water storage heater. There is a significant risk of
damaging the boiling water storage heater.
Technical specifications
Boiling water storage heater electrical data:
• Connection:
Wall socket with earth wire,
protected with a 16 A fuse
• Voltage supply:
230V AC / 50Hz
• Power consumption:
2100 W
• Standby power loss (switched on):
15 W
• Standby power loss (switched off):
1 W
• Type of protection:
IPX4
Filter system:
• Sensor battery:
3 V lithium battery (type CR 2032)
• Cable length:
1500mm
• Type of protection unit (wall installation):
IPX4
• Type of protection rating:
IPX8
Sanitary data for boiling water storage heater, fitting:
• Boiling water storage heater capacity:
8 l
• Flow pressure:
- min.
0.1 MPa
- recommended
0.1-0.5 MPa
• Operating pressure:
max. 0.2-0.8 MPa
• Test pressure:
0.16 MPa
• Flow rate at 0.3 MPa flow pressure
- mixed water:
approx. 7 l/min
- boiling water:
approx. 3.5 l/min
• Hot water temperature can be set at the storage heater:
35 °C-75 °C
• Boiling water temperature:
100 °C
The actual temperature may differ slightly due to different
ambient pressures
• Heating time from 10 °C to 100 °C:
approx. 30 min
• Available storage heater volume at 100 °C:
6 l/min
• Available storage heater volume at 60 °C:
11 l/min
• Max. Chlorine value:
100 mg/l
• Clamping length of fitting:
max. 60 mm
• Water connection at storage heater:
Cold water
• Water connection at fitting:
Cold water from service valve
Hot water from storage heater
Boiling water from storage heater
