grohe.com
Page 7
ENTER AND SELECT
THE FUNCTION MENU
2-4 sec
The “Function Menu” contains the following
submenu
F1 – “Automatic filling/safety shut-off”
F2 – “Calibration”
F3 – “Controller & Diverter Log-On”
F2 and F3 are for use by a Service Engineer only.
Press and hold “+” and “-” for 2-4 sec to enter
the “Function Menu” while the Digital Controller
is switched off. Turn the outer ring to select the
specific function.
Timeout function ensures menu drop out
after 3 min.
CHANGE AND SAVE SETTING OF F1
AUTOMATIC FILLING/SAFETY SHUT-OFF
The time after the faucet/shower switches off
automatically can be changed.
Enter the function menu and select F1 as
described above. Press “+” and “-” to confirm.
The timer and water flow start automatically after
confirmation.
Turn the outer ring to select the outlet (only bath
and shower) and confirm with “+” and “-”.
CHANGE AND SAVE THE SETTING
Turn the outer ring counter-clockwise to stop the
timer. To re-start the timer, turn the outer ring
clockwise. Press “+” and “-” to save and leave
the menu.
All digital fittings are adjusted to the following parameter
Cold water supply: 15° C I Hot water supply: 65° C I Pressure: 3 bar
FACTORY SETTINGS
(DEFAULT)
CONTACT
GROHE
Digital basin mixer
Digital sink mixer
Digital bath & shower
Flow rate
3/4 of max. volume
3/4 of max. volume
3/4 of max. volume
Temperature
23° C
23° C
37° C
Max. Temperature
56° C
56° C
46° C / US: 42° C
SafeStop
42° C
42° C
38° C
Automatic filling/
safety shut-off
1 min.
1 min.
20 min.
CARE
INSTRUCTIONS
Please read the following care instructions because
damage to the surface and underlying material
resulting from improper treatment is not covered
by warranty.
Do not use any abrasive sponges or scouring
agents for cleaning. We also advise you not to use
cleaning agents containing solvent or acid, limescale
removers, household vinegar and cleaning agents
with acetic acid in them. They are aggressive to the
surface and will leave your fitting dull and scratched.
As the formulations of commercially available
cleaning agents frequently change, we cannot
guarantee they will provide the gentle care our
fittings deserve.
Clean the fitting with a little soap and a moist cloth
only, then simply rinse off and wipe dry. You can
avoid lime spots by drying the fitting each time it is
used. If lime deposits do occur, remove them with
GrohClean, our environmentally-friendly cleaning
liquid. GrohClean is specially formulated to clean the
surface of our fittings gently. GrohClean is available
from your supplier.
Low battery capacity is indicated by a shorter display duration of the illuminated ring.
Battery type: 3x CR2450 (3V)
Only use new batteries of same make and type. Do not use rechargeable batteries.
REPLACING
THE BATTERIES
Make sure the control
unit is dry before
removing.
Pull the Digital Control
Unit to remove it from
the fixation plate.
Use a coin to turn the
back plate.
Remove the back plate. Replace all batteries.
F1
1x
F2
2x
F3
3x
3x
1x
LEAVE
THE FUNCTION MENU
Press and hold “power/pause” for 2-4 sec
to leave the function menu.
Indication by illuminated ring if function menu has
been left.
2-4 sec
1x
