CONCETTO
WALL BA
TH
MIXER SET TRIM
MODEL #1
957500
5
Installation instructions
www.grohe.com
7
6
H
8
9
Flush piping system prior and after installation of fitting
thor
thor
oughly!
This product must be installed in conformance with local
codes e.g. AS/NZS 3500 series of standard!
Installatio
n and connection, see Figs [1] to [9].
Refer to the dimensional drawing above. For installation
with
32 635
000 concealed in-wall body. PLEASE NOTE –
Face o
fof
noggins need to be positioned a minimum of
43mm & a maximum of 73mm from where the finished
wall surface will end up.
Note:
When installing concealed mixer body, please note it must be
mounted onto timber or solid walls using appropriate reinforcement
to ensure sufficient strength.
Open cold and hot water supply and check connections for leakage!
Care
For directions on the care of this fitting, please refer to
the
accompanying care instructions.
1. Determine dimension “Y” from the leading edge of built-in
fitting housing to face of tiles, see Fig. [6].
2. Cut connection nipple (H) so that the installation dimension
is “Y” + 22mm.
3. Using an 12mm allen key, screw connection nipple (H) into
the built-in fitting housing until the installation dimension
is 10mm. Tighten spout (I) from below using an 2,5mm allen
key, see Fig. [7].
Open hot and cold water supply and check connections
for watertightness!
Check fitting for correct operation, see Fig. [8].
Installation Instructions
Shut off hot and cold water supply.
I. Install escutcheon and lever, see Figs. [3], [4] and [5].
1. Attach cap (A), see Fig. [3].
2.Grease seal (B1) and push on escutcheon (B), see Fig.
[4].
3. Attach insulating insert (C) and secure with screw (D),
see
Fig. [5].
4. Attach lever (E), screw in set screw (F) using an 3mm
allen
key and insert plug (G), see Fig. [5].
If the escutcheon will not slide far enough onto the cap,
you
must additionally install an extension (see replacement
parts
fold-out page I, Prod. no.: 46 627 = 25mm).
II. Install spout, see Figs. [6] and [7].
