OM-TDB TA/2
7
Slip-On Coupling
!
Adequate clearance for tilting
!
Access for service
!
Unit fastened down
!
Mixer power supply conforms to
information plate and code
!
Electrical conduit and connections are
waterproof
!
Mixer grounded
For instructions on installing the kettle
component of your cooker/mixer, see the
separate kettle manual.
B. Initial Start-Up
After the mixer is installed, take the following
actions to confirm that the equipment is
operating correctly.
1. Tilt the mixer through its complete tilting
range to ensure that there is no hazard or
interference.
2. Make sure the agitator is properly coupled
with its drive shaft. If the mixer has a slip-on
coupling, the drive pin must be positioned at
the end of the J-slot.
3. When the mixer is in operating position,
every scraper blade should touch the inside
of the kettle during at least part of each
revolution of the agitator.
d. At the circuit breaker or fuse box, turn on the
electric power supply to the mixer.
e. Switch on the drive and confirm that the
mixer operates smoothly. For a variable
speed model, confirm that the mixer
operates correctly throughout its speed
range.
f.
Make sure the agitator turns in the correct
direction, so it pushes the nylon scraper
blades ahead of the agitator bar.
If the unit functions as described above, it is
ready for use. If the unit does not function as
intended, call your local Groen authorized
service agency.
For instructions on initial start-up of the
kettle component of your cooker/mixer, see
the separate kettle manual.
WARNING
TURN OFF AGITATOR BEFORE ADDING
INGREDIENTS OR INSPECTING KETTLE
CONTENTS. DO NOT WEAR LOOSE
CLOTHING OR JEWELRY AROUND
OPERATING MIXER KETTLE. KEEP WELL
CLEAR OF ROTATING MIXER ARMS AND
PADDLES AT ALL TIMES.
