Model T32006 (Mfd. Since 01/20)
-26
-
Aligning Pulleys
Pulley alignment is an important factor in
power transmission and belt life. The pul-
leys should be parallel to each other and
in the same plane (coplanar) for optimum
performance.
Each pulley can be adjusted by loosening
the set screws that secure them to their
respective shafts.
Items Needed
Qty.
Wrench or Socket 7mm ............................ 1
Straightedge 6" ......................................... 1
Hex Wrench 2mm ..................................... 1
To align pulleys:
1. DISCONNECT TOOL FROM POWER!
2. Remove headstock cover.
3. Place a straightedge on top of both
pulleys (see
Figure 24) and check that
they are aligned. There should be no
space anywhere between straightedge
or pulleys.
— If pulleys are aligned, proceed to
Step 8.
— If pulleys are not aligned, proceed
to
Step 4.
Figure 24. Checking pulley alignment.
Pulleys
5. Loosen set screw on motor pulley
shown in
Figure 25.
Figure 25. Motor pulley set screw location.
Motor Pulley
6. Use straightedge to align pulleys, then
tighten set screw from
Step 5.
7. Install drive belt according to desired
speed range (refer to
Changing
Spindle Speed on Page 19 for more
information).
8. Install headstock cover.
4. Remove drive belt (refer to Changing
Spindle Speed on Page 19).
Summary of Contents for T32006
Page 32: ......
