Grizzly T32005, Owner'S Manual, Page: 17 / 24

Model T32005 (Mfd. Since 04/20) -15
-
Securing Workpiece Cutting
Workpieces must be secured with the built-
in vise. Unsecured workpieces increase
the risk of injury due to kickback or loss
of control.
To secure workpiece:
1. DISCONNECT TOOL FROM POWER!
2. Loosen vise miter clamp, set miter
angle, then tighten vise miter clamp
(see
Figure 8).
3. Loosen vise until workpiece fits between
vise jaws, then tighten vise until
workpiece is secure (see
Figure 8).
Figure 8. Workpiece vise controls.
Vise Miter Clamp
Vise Screw
Workpiece
The Model T32005 can cut wood or
metal workpieces
3
⁄
8
" thick or small-
er. Always ensure the correct blade
is used for the material being cut.
4. Wait for blade to come to a complete
stop, raise blade, then press power
switch to
O position to turn tool OFF.
5. Remove workpiece from vise.
To reduce risk of eye injury from
flying chips or lung damage from
breathing dust, always wear safety
glasses and a respirator when oper-
ating this tool.
Figure 9. ON/OFF lever during cut.
To cut workpiece:
1. Ensure workpiece is secure in vise.
2. Press power switch to I position to turn
tool
ON.
3. Fully press ON/OFF lever (see Figure
9). Once saw blade comes to full
speed, lower blade into workpiece.
ON/OFF
Lever