Model T31739 (Mfd. Since 11/19)
-23-
The arbor can be removed to install other Morse
Taper #2 tooling in the spindle. A drift key is
included to help remove the arbor or other tooling
from the spindle.
Figure 24. Drift key slot exposed.
3. Adjust feed return stop nut shown in Figure
25 so it touches stop bracket. The quill should
not return up into the head casting when
depth stop is adjusted this way.
4. Move table up until it is
1
⁄
4
" below bottom of
chuck, and place a towel or cloth under the
chuck.
Figure 25. Feed return stop nut location.
Return Stop
Nut
Stop Bracket
2. Rotate downfeed handles until drift key slot is
exposed in side of quill (see
Figure 24).
Drift Key
Slot
Figure 27. Using drift key to remove arbor from
spindle.
7. Tap drift key with a metal hammer (see
Figure 27) until chuck releases.
8. Hold downfeed handle with one hand, and
adjust feed return stop back to bottom of
depth stop with the other hand.
9. Carefully retract the quill into the headstock.
Figure 26. Inner and outer drift key slots aligned.
Both Slots
Aligned
6. Insert drift key into drift key slot, and allow
quill to rise, trapping drift key.
5. Rotate spindle until inner drift key slot is
aligned with outer slot (see
Figure 26). You
will see through the spindle when the slot is
properly aligned.
Items Needed
Qty
Metal Hammer ................................................... 1
Towel or Cloth .................................... As Needed
1. DISCONNECT MACHINE FROM POWER!
Removing Drill Chuck Arbor
To remove drill chuck arbor:
Summary of Contents for T31739
Page 44: ......
