-26-
Model T31681 (Mfd. Since 12/19)
Symptom
Possible Cause
Possible Solution
Blade or teeth
break/crack.
1. Blade tension is incorrect.
2. Blade is incorrect for application.
3. Feed rate/pressure is too heavy.
4. Blade is dull/worn or blade weld at fault.
5. Blade is tracking incorrectly.
1. Adjust blade tension (
Page 18).
2. Use correct blade for application.
3. Reduce feed pressure.
4. Replace blade (
Page 16).
5. Adjust blade tracking (
Page 17).
Blade tracks
incorrectly or comes
off wheels.
1. Tracking is not adjusted properly.
2. Blade tension too loose.
3. Feeding meat/bone too fast.
4. Incorrect blade for saw.
1. Adjust blade tracking (
Page 17).
2. Increase blade tension.
3. Feed workpiece slower.
4. Install correct blade.
Cuts are not straight
and clean.
1. Feed rate/pressure is too heavy.
2. Blade tension too loose.
3. Blade is too narrow or tooth type/TPI is
incorrect for the cut.
4. Blade dull or has damaged tooth set.
5. Blade tracking is incorrect.
1. Reduce feed rate/pressure.
2. Increase blade tension (
Page 18).
3. Use wider blade. Ensure tooth type & TPI is correct.
4. Replace blade (
Page 16).
5. Adjust blade tracking (
Page 17).
Material difficult to
move across table.
1. Material built up on table.
1. Clean and sanitize table, then apply a thin coat of
food-grade lubricant (
Page 20).
Saw Operation
Summary of Contents for T31681
Page 36: ......
