Grizzly T28959, Owner'S Manual

Page: 17 / 36

Model T28959 (Mfd. Since 2/19)
-15-
2. Remove angle knob from chain holder
assembly (see
Figure 17).
3. Attach chain holder assembly to base (see
Figure 17).
4. Secure chain holder assembly to base with
angle knob (see
Figure 17).
Figure 16. Depth stop knob assembly.
Depth Stop Knob Assembly
Swing Arm
Assembly
The Model T28959 is shipped partially assem-
bled. Perform the following procedure to complete
the assembly.
To assemble the sharpener:
1. Thread depth stop knob assembly into hole
on swing arm (see
Figure 16).
Figure 17. Attaching chain holder assembly to
base.
Chain
Holder
Assembly
Angle
Knob
Base
Number of Mounting Holes ............................ 2
Diameter of Mounting Hardware Needed ..
3
⁄
8
"
Stop
Flange
Figure 15. Stop flange against the workbench.
Base
To mount the sharpener:
1. Place base flat on workbench, slide it back
until stop flanges (see
Figure 15) hit front of
the workbench.
2. Mark mounting hole locations and move base
to side.
3. Drill holes in workbench surface.
4. Re-position base over holes and use appro-
priate hardware to securely mount base to
workbench using Through Mount or Direct
Mount techniques (see
Figures 13 and 14 on
Page 14).
Angle
Knob