Grizzly T27950, Instructions, Page: 2 / 4

-2-
T27950 Tool Cabinet (Mfd. 10/16)
To adjust doors:
1. Close door and visually confirm gap spacing
around door edge is
1
⁄
8
" all the way around
(see Figure 3).
— If door spacing is equal, no adjustments
are needed.
— If door spacing is not equal, proceed to
Step 2.
Figure 3. Checking door gap spacing.
1
⁄
8
" Gap
Maintenance
• Use a soft, clean cloth and soapy water (use
regular dish soap) to remove grease, dirt, or
oil. Do not use solvents or flammable clean-
ing liquids.
• Use graphite to lubricate lock annually.
Installing Shelf Supports
Each shelf comes with four shelf supports, which
fit into the channel brackets inside the cabinet
(see
Figure 6), making the height of each shelf
adjustable. (Shelf supports must be mounted
evenly to function properly.)
Shelf
Support
Channel
Bracket
Figure 6. Shelf support and channel bracket.
2. Adjust door hinges using screws shown in
Figure 4.
Note: Only small adjustments, such as
1
⁄
8
or
1
⁄
4
turn at a time, are required to move
door position. Check spacing after each
adjustment.
Figure 4. Hinge adjustments.
In/Out
Adjustment
Right/Left
Adjustment
Mounting
To mount, locate wall studs at desired mount-
ing location. Pre-drill (2)
1
⁄
4
" mounting holes into
wall cabinet to align with each stud, and secure
cabinet to the wall (see
Figure 5). Due to the load
capacity of the cabinet, always mount directly to
wall studs!
Cabinet Body
Wall
Stud
(1 of 2)
Lag Screw
Flat Washer
Figure 5. Mounting cabinet to wall.
Hardware Needed Qty
• Socket Wrench
3
⁄
8
" ....................................... 1
• Flat Washers
1
⁄
4
" ......................................... 2
• Lag Screw
1
⁄
4
"-20 x 1" .................................. 2
Adjusting Doors
Each 90° soft-close door hinge is riveted in place.
However, the doors may be adjusted inward or
outward, and left or right, as needed.