Grizzly T27139, Owner'S Manual

Page: 14 / 32

Model T27139 (Mfd. Since 3/16) -11
-
Figure 7. Collet wrench and lock button.
Spindle
Lock Button
Collet
Wrench
SECTION 4: OPERATIONS
Removing/Installing
Router Bit
This router is supplied with a
1
⁄
4
" collet for
use with
1
⁄
4
" shank router bits. Carefully
inspect router bits for cracks, chips, or
other damage before installing.
DO NOT
use router bits that have been dropped,
cracked, or damaged. The router bit may
shatter, causing serious injury.
To remove or install router bit:
1. DISCONNECT TOOL FROM POWER!
2. To access collet, release clamping
lever and remove laminate trim router
from base.
3. Align spindle lock button pin with spin-
dle shaft, and press lock button.
4. Use collet wrench to loosen collet nut,
and remove router bit (see Figure 7).
5. Slide router bit to within
1
⁄
8
" of the bot-
tom of collet, press lock button, then
securely tighten collet with wrench.
Note: The collet can be damaged if it
is tightened without a bit.
Adjusting Bit Depth
Unplug router and make sure switch
is OFF before inserting or removing
bit, making adjustments, or perform-
ing maintenance or service. DO NOT
make adjustments while router is
connected to power. Serious injury
may occure if this is ignored.
Router bit is sharp and will be hot
after use. Wear gloves to prevent
injury when removing bit.
To adjust bit depth using fixed base:
1. DISCONNECT TOOL FROM POWER!
2. Loosen clamping lever shown in
Figure 8, and adjust base to approxi-
mately desired height with the height
adjustment knob.
Figure 8. Height adjustment knob.
Height
Adjustment
Knob
Clamping
Lever