-2-
Model T26673/T26674 (Mfd. Since 02/14)
Installation
1. Place switch box in a dry, protected location
within reach of power receptacle and dust
collector power cord.
2. Plug switch box into proper power receptacle
(see
Figures 2–3).
Grounding Prong
Neutral Hot
5-15 PLUG
120V
GROUNDED
5-15 RECEPTACLE
Figure 2. NEMA 5-15 plug and receptacle for
Model T26673.
For T26673
3. Make sure dust collector ON/OFF switch
is turned
OFF, then plug dust collector into
switch box.
Grounding Prong
Current Carrying Prongs
6-20 PLUG
240V
GROUNDED
6-20 RECEPTACLE
Figure 3. NEMA 6-20 plug and receptacle for
Model T26674.
For T26674
Operation
The remote controller and switch box come pre-
programmed from the factory and are ready for
use. No additional programming is necessary.
To operate the remote controller:
1. After carefully following installation instruc-
tions, turn dust collector ON/OFF switch to
ON.
2. Press remote controller ON button once to
turn dust collector
ON. Red light on remote
controller will illuminate at "0" hours (see
Figure 4).
Figure 4. Indicator lights on remote controller.
Programming Auto Shut-Off
Using the remote controller, you can program your
switch box to automatically shut off your dust col-
lector after a specified number of hours.
Note: At no point should your dust collector be left
running while unattended.
To program auto shut-off:
1. Press ON button on remote controller.
2. Use left/right buttons to move red indicator
light at top of controller to the desired setting.
3. Press remote controller OFF button once to
turn dust collector
OFF. Red light on remote
controller will go out after a few seconds.
