Model T1250 (Mfd. Since 10/17)
-3-
6. Secure end frames, center frame, and
lower supports with (2) external corners and
(4) internal corners, using (10) M8-1.25 x 55
button head cap screws, (20) 8mm flat wash-
ers, and (10) M8-1.25 lock nuts (see Figure
7).
DO NOT fully tighten fasteners yet.
7. Thread (6) rubber feet into bottoms of frames
(see
Figure 8).
Figure 9. Steel bars inserted.
Center
Frame
End Frame
Steel Bars
Figure 7. End frame, center frame, and lower
supports secured together with corners.
Upper Frame
Support
x 6
End Frame
Center Frame
x 4
Internal
Corner
Internal
Corner
External
Corner
Figure 8. Rubber feet attached.
End Frame
Center
Frame
Rubber
Foot
8. Turn workbench upright and make sure it is
centered over end frames and supports (not
leaning to one side or the other), then fully
tighten all fasteners.
9. Adjust feet as necessary to ensure work-
bench sits firmly on ground and does not
rock.
Option: Lay a level across workbench from
side-to-side and end-to-end when adjusting
feet.
10. Insert steel bars through end support frames
as desired (see
Figure 8).
Note:
End frames have several
holes, allowing for numerous shelving and
racking configurations.
