model t10097 Wet grinder
-11
-
test run
once your model t10097 is positioned,
test run the machine to make sure it runs
properly.
if, during the test run, you cannot easily
locate the source of an unusual noise or
vibration, stop using the machine imme-
diately, then review the
troubleshooting
on
page 20
.
if you still cannot remedy a problem, con-
tact our tech support at (570) 546-9663
for assistance.
to test run the machine:
1.
make sure you have read the safety
instructions at the beginning of the
manual and that the grinder is setup
properly.
2.
make sure all tools and objects used
during set up are cleared away from
the grinder.
3.
make sure the switch is in the oFF
position.
4.
Connect the grinder to the power
source.
5.
turn the grinder
ON
. make sure that
your hand stays poised over the switch
in case you need to quickly turn the
machine oFF.
6.
listen to and watch for abnormal nois-
es or actions. under normal conditions,
the grinder will make a humming noise,
with only minor vibration.
— investigate strange or unusual nois-
es and correct them before oper-
ating the machine further. always
disconnect the machine from power
before investigating or correcting
potential problems.
7.
turn the grinder
Off
.
8.
pull out the switch disabling key and
attempt to turn the machine
ON
.
— if the grinder does not start, the
switch disabling feature is working.
— if the grinder starts, turn it
Off
.
the switch disabling feature is not
working. this safety feature must
work properly before proceeding.
Call tech support for help.
4.
an undamaged wheel will emit a clear
metallic ring or “ping” sound in each
of these spots. a damaged wheel will
respond with a dull thud that has no
clear tone.
5.
if you determine from the ring test that
the wheel is damaged, do not use it!
Finally, check that the
grinding surface
is square.
lower the universal support to
1
⁄
16
"-
1
⁄
8
" above the grinding wheel. using
the universal support as a visual guide,
check that the entire surface of the grind-
ing wheel is consistent and parallel to the
universal support, as shown in
figure 5
. (if
this is not the case, see
Wheel dressing
on
page 19.
)
figure 5.
parallel check.
universal
support
grinding
surface
Check
parallel
