-12-
t10095 Cement Mixer
Test Run
once assembly is complete and you have read
and understand this entire owner's manual, con-
nect the machine to the power source, then test it
to make sure it runs properly.
if there is an unusual noise or vibration, stop
the machine immediately and inspect it for loose
fasteners or improperly assembled pieces. if you
still cannot remedy a problem, contact our tech
Support at (570) 546-9663 for assistance.
10.
if available, apply anti-seize paste on the
M10-1.5 x 25 hex bolts, then use them with
the M10-1.5 hex nuts to secure the two mix-
ing blades to the inside of the drum assem-
bly, as shown in
Figure 13
.
6.
place the lower drum half on over the motor
assembly shaft that protrudes from the frame
plate (
Figure 9
).
Figure 9.
lower drum installed on frame.
7.
Align the holes in the lower drum and motor
assembly shaft, and insert the threaded pin,
as shown in
Figure 10
, and secure it on the
other side with the M10-1.5 lock nut.
Figure 10.
Securing lower drum on shaft.
8.
lay the gasket out along the circumfrence of
the lower drum, taking care to align the holes
in the gasket with those in the lower drum
(
Figure 11
). If necessary, use a little contact
adhesive to stick the gasket to the drum.
Figure 11.
gasket laid out on lower drum.
9.
place the upper drum on the lower drum and
gasket, align the holes, and fasten it to the
lower drum with the M6-1 x 20 hex bolts,
fender washers, flat washers, lock washers,
and hex nuts—as shown in
Figure 12
.
Figure 12.
Upper drum attached to lower drum.
Figure 13.
Mixing blade attached to drum
assembly.
