Grizzly H8259, Owner'S Manual

Page: 20 / 36

-18-
H8259 10" x 18" Benchtop Lathe
•
Scrapers
—Mainly used where access for
other tools is limited, such as hollowing oper-
ations. This is a flat, double-ground tool that
comes in a variety of profiles (Round Nose,
Spear Point, Square Nose, etc.) to match
many different contours.
Figure 21 shows an
example of a round nose scraper.
Figure 21.
Round nose scraper.
Figure 22.
Parting tool.
•
Parting Tools
—Used for sizing and cut-
ting off work. This is a flat tool with a sharp
pointed nose that may be single- or double-
ground.
Figure 22 shows an example of a
parting tool.
• Specialty Tools —These are the unique,
special function tools to aid in hollowing, bowl
making, cutting profiles, etc. The Swan Neck
Hollowing Tool shown on
Page 23
is a good
example of a specialty tool.
Selecting Turning
Tools
Lathe tools come in a variety of shapes and sizes
and usually fall into five major categories.
• Gouges —Mainly used for rough cutting,
detail cutting, and cove profiles. The rough
gouge is a hollow, double-ground tool with
a round nose, and the detail gouge is a hol-
low, double-ground tool with either a round or
pointed nose.
Figure 19
shows an example
of a gouge.
Figure 19.
Gouge.
• Skew Chisel —A very versatile tool that can
be used for planing, squaring, V-cutting,
beading, and parting off. The skew chisel
is flat, double-ground with one side higher
than the other (usually at an angle of 20-
40˚).
Figure 20
shows an example of a skew
chisel.
Figure 20.
Skew chisel.