Model H8232 3-Piece Framing/Finish/Palm Nailer Kit
-13
-
Figure 11.
Nose opened to clear a jam.
Nose Cover
Nose Release
Nose Tip
4.
Dislodge the jammed nail with a tool
that will fit in the slot on the underside
of the nose.
5.
Throw the damaged nail away and
insert a new nail strip that only contains
clean, undamaged nails. DO NOT use
dirty or damaged nails!
6.
Close the nose cover and replace the
nose tip. Then release the catch lever
and let the pusher slide to the front of
the magazine.
Replacing Pistons/
O-Rings
Under heavy use, a piston, piston shaft,
or O-ring may wear out. Replacement is
quick and easy. Contact Grizzly Customer
Service at (800) 523-4777 to obtain the fol-
lowing Piston Repair Kits or the Complete
O-Ring Repair Kits.
Nailer Repair Kit
Part Number
Framing Nailer:
Piston Repair Kit ............... PH7665095
O-Ring Repair Kit .............. PH7665096
Finish Nailer:
Piston Repair Kit ............... PH8232091
O-Ring Repair Kit .............. PH8232092
Palm Nailer:
Piston Repair Kit ............... PH6141026
O-Ring Repair Kit .............. PH6141027
Always disconnect air from nailer
whenever servicing! During mainte-
nance, a nailer connected to air may
fire accidentally, causing serious per-
sonal injury!
Framing & Finish Nailer
To replace a piston in your framing or
finish nailer:
1.
DISCONNECT NAILER FROM THE
AIR SUPPLY!
2.
Remove all nails from the magazine
cartridge, and clean the exterior of the
nailer.
3.
Remove the four cap screws on the
back of the nailer, near the exhaust
port.
4.
Remove the cap.
5.
The top of the piston should now be
visible inside the cylinder, which is
housed in the head of the nailer.
6.
Watch the discharge area and push the
top of the piston with your finger. You
will see the piston shaft slide down the
discharge area.
