Model H8210 10 Piece Air Hammer Kit
-5
-
To use the air hammer:
1.
Attach the
1
/
4
" NPT male quick connect
fitting to the air inlet plug.
2.
Attach the air hammer to an air supply
set at 90 PSI.
3.
Hold the air hammer securely.
4.
Use the trigger to
START
and
STOP
the
air hammer.
5.
To avoid accidental starting, discon-
nect air hammer from air supply when
not in use.
Daily Maintenance
The air hammer MUST have 2-6 drops of
oil directly dropped into the air fitting before
each use. In addition, we recommend using
an in-line filter, lubricator, and regulator as
shown in
Figure 4.
ACCIDENTAL
START HAZARD!
Disconnect before
service or tool
changes.
AIR PRESSURE
HAZARD!
Never exceed max
PSI rating for tool.
EAR/LUNG
INJURY HAZARD!
Wear protective
equipment when
using this tool.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 4.
Installed filter lubricator
regulator.
EYE INJURY
HAZARD!
Wear protective
equipment when
using this tool.
These procedures should be done after
each use:
•
Wipe the motor housing and tool bits with
a dry cloth, or blow off the dust and debris
with compressed air.
•
Check for damage to tooling, hoses,
housing or other accessories. Promptly fix
if damage is found before using again.
Summary of Contents for H8210
Page 2: ......
