Grizzly H8155, Owner'S Manual

Page: 14 / 24

-12-
H8155 MIG Welder
Figure 8. Feeding the wire.
5. Open the wire feed mechanism as shown in
Figure 7
.
Figure 6.
Replacing the wire spool.
Figure 7.
The open wire feed mechanism.
6. Feed and guide the spool wire into the wire
feed mechanism, and into the small tube just
past the feed wheels
( Figure 8 ). Continue to
guide the wire until comes out of the control
tip on the torch assembly.
Note: It will help if the welding torch cable is
straightened out as much as possible. Push
in until the wire comes out the welding torch
head. If it cannot be fed manually all the way
out, it can be fed automatically when the
welding unit is powered up.
1. DISCONNECT THE WELDER FROM
POWER.
2.
Periodically open the top and side panels.
Using compressed air, blow out all dust from
the interior.
3.
Store the unit in a clean and dry location.
4.
Periodically clean out the torch head.
Installing the wire spool
1.
DISCONNECT THE WELDER FROM
POWER.
2. Lift the side panel to expose the wire spool
axle and the wire feed mechanism.
3.
Remove the wing nut and spool nut from the
wire spool axle and remove the wire spool.
4. Place the new wire spool over the axle
with the wire exiting the spool over the top.
Replace the retaining nut and wing nut and
adjust until snug (
Figure 6
).
Maintenance