-2-
model h8110 (mfg. since 7/09)
E
C
F
E
figure 13. Lower panel installation.
5. place a flat washer (e2) on each barrel bolt
(e3), and insert the bolts through the right-
side leg (
figure 12).
6. Using a 5mm hex wrench, thread the bolts
into the barrel nuts (e4) (
figure 12), but do
not fully tighten at this time.
7. insert the lower panel (F) into the slots of
the two lower cross braces (e), and into the
groove of the side leg (
figure 13).
8. insert both central drawer support panels (h)
(
figure 14) into the cross brace (e) slots.
E
C
H
F
figure 14. drawer support installation.
9. install the two upper cross braces (d) (figure
15) into leg (C) the with the same hardware
and methods covered in
Steps 1-7. do not
fully tighten the hardware yet.
D
E2
E3
D
F
C
figure 15. Upper cross panel installation.
10. insert the upper panel (F) into the slot of
the two upper cross braces (d) and into the
groove of the side leg (
figure 15).
11. insert the remaining four barrel nuts (e4)
(
figure 16) into the other end of the previ-
ously installed cross braces.
make sure that the slotted end of the barrel
nuts face outward and the screwdriver slots
are aligned horizontally with the direction of
the cross braces.
12. position the left side leg (B) on the floor so
the Up arrow is pointing upward and the
Front arrow points to the front as shown in
figure 16.
E4
B
E3
E2
E4
Front
Up
figure 16. Left leg installation.
13. Carefully engage the slots in the left leg with
the cross supports and panels, and place a
flat washer (e2) on each remaining barrel bolt
(e3) (
figure 16).
