-16-
Model H8070 (Mfg. Since 7/06)
installing output
Jack
components and hardware needed:
Qty
output Jack ....................................................... 1
output Jack Cover ............................................. 1
Chrome screws 3.1 x 12mm .............................. 2
to install the output jack:
1. thread the output jack onto the jack cover.
2. place the output jack cover in the jack cavity,
and mark the mounting holes.
3. using a
1
/
16
" drill bit, drill
3
/
8
" holes at a 45º
angle into the body as shown in
figure 23.
figure 23. drilling output jack mounting holes.
4. Mount the output jack cover with two 3.1 x
12mm screws.
installing bridge,
pickups & controls
figure 24. ground wire above bridge cavity.
3. secure the bridge with the 3.5 x 25mm
screws, and fasten the control plate with 3.1
x 12mm
screws.
to reduce humming in your amp, the ground wire
must contact the bridge plate.
components and hardware needed:
Qty
guitar Body ....................................................... 1
pick guard ......................................................... 1
Chrome screws 3.5 x 25mm ............................. 4
Chrome screws 3.1 x 12mm .......................... 10
to install the control plate and pickups:
1. tape the ground wire so the exposed por-
tion curls over the bridge cavity as shown in
figure 24.
2. place the bridge into the cavity so the plate
makes contact with the wire.
ground Wire
