Using the Cleaning Gun
1. Connect the air hose to the cleaning gun.
2. Pour detergent or a solvent into the container.
Never use corrosive fluids in the container.
3. Tightly connect the container to the cleaning
gun body and aim nozzle at the parts that
need to be cleaned.
4. Pull trigger.
5. Adjust the nozzle as shown in Figure 3 until
the amount of fluid is correct.
6. Lock the nozzle adjustment by screwing the
back section of the nozzle towards the front.
7. Maintain the cleaning gun by doing the
following:
A. Clean the cleaning gun after each use by
spraying a small amount of thinner. DO
NOT immerse the cleaning gun in the
thinner.
B. Use a soft bristle brush soaked with
thinner when cleaning inside the cleaning
gun.
C. The trigger and springs should be
lubricated periodically.
Fluid
Container
Cleaning
Gun
Body
Nozzle
Figure 2. Cleaning gun components.
Figure 3. Adjusting flow.
Using the Tire Inflator
1. Connect the air hose to the tire inflator.
2. Connect inflator to the tire air valve.
3. Pull the trigger until the appropriate air
pressure is reached.
4. If the pressure in the tire is too high, push the
pressure release valve to bleed the excess
pressure.
Figure 4. Tire inflator components.
Inflator
Trigger
Pressure
Gauge
Pressure
Release
Valve
1. Attach the blow gun to the air supply with the
air hose.
2. Aim the blow gun at the workpiece and pull
the trigger. DO NOT point the blow gun in the
direction of a human body.
Using the Blow Gun
COPYRIGHT © SEPTEMBER, 2003 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
PRINTED IN CHINA
If you need additional help with these procedures,
call our service department at: (570) 546-9663.
