H3390 Wet Tile Saw
-15-
Lubrication
To prevent excessive wear on the saw blade, be
sure to maintain a continuous flow of water on
both sides of the blade. Never cut tile without the
water lubrication system running.
To set up the water lube system:
1.
Assemble the pump and hoses as described
on
Page 12
.
2.
Position the pump so it does not interfere
with the movement of the table.
3.
Fill the water reservoir with enough water to
completely cover the suction inlet on the
pump as shown in
Figure 19
. DO NOT over-
fill the reservoir.
4.
The pump turns on when the saw is turned
on. The water flow can be adjusted using the
flow rate lever on the side of the pump.
Figure 19.
Filled water reservoir.
Summary of Contents for H3390
Page 27: ...22 H3390 Wet Tile Saw 61 70 65 66 68 67 64 63 62 60 69...
Page 29: ...24 H3390 Wet Tile Saw NOTES...
Page 30: ...H3390 Wet Tile Saw 25 NOTES...
Page 34: ......