Model H3253, H3254, H3255 Spray Gun
-10
-
7.
Adjust the fluid control knob to start
with a low volume of material and keep
the atomization as low as possible.
You will need to use a combination of
fluid control, inlet air pressure, air flow
control and stroke speed to achieve the
results you want. Spray so the material
wets out nicely without running or sag-
ging.
8.
Use the pattern control knob to adjust
the spray fan to your desired pattern.
9.
Keep the gun tip perpendicular, parallel
and 6-12" from the work at all times
when spraying, as shown in
Figure
7
. Do not allow your wrist to bend.
This will cause the gun to arc across
the surface and distribute the material
unevenly, possibly creating sags and
dry spots.
10.
Begin spraying 2-3 inches before the
work and continue to the end of the
work. Continue the motion for a few
inches past the work until you are
ready for the return stroke.
11.
Maintain an even speed when spray-
ing.
12.
Overlap each stroke by 50%. This will
ensure even coverage as shown in
Figure 8
. Overlapping less than 50%,
as shown in the figure to the right,
may lead to missed spots or streaky
results.
NOTICE
Tipping the spray gun may cause
material to spill out of the cup. Always
hold the spray gun perpendicular to
the ground to avoid potential spills
and feed problems.
��
���
Figure 7.
Spray technique.
��
���
Figure 8.
Overlap technique.
13.
The spray stroke should have even con-
sistency and parallel edges. If it doesn't,
please refer to
Troubleshooting
on
Page 15.
No
Yes
CONTAMINATION HAZARD! Dispose
of paint waste in a responsible man-
ner! Follow manufacturer's recom-
mendations and local laws regarding
disposal.
