REMOVAL & INVENTORY
1.
Remove your new wagon from the carton.
2.
Make sure all parts are present and in good
condition.
FRONT SUPPORT ASSEMBLY
1.
Insert the yoke into the front axle support
by sliding the top hole of the yoke onto the
pivot post on the front axle support. Place
the 10mm flat washer on the pivot post and
slide the cotter pin in the pre drilled hole and
spread. Bolt the center front axle brace and
yoke to the bottom of the front axle support
with the M8-1.25 x 17 shoulder bolt, 6mm flat
washer and lock nut. See
Figure 1
ASSEMBLY INSTRUCTIONS
Figure 1.
Front axle assembly detail.
Figure 2.
Rear and front axle assemblies
Yoke
Steering
Connector
Front axle
support
Center front
axle brace
2.
Bolt the steering connector to the steering
arms of the front axle support and the yoke
using M8-1.25 x 15 shoulder bolts, 6mm flat
washers and lock nuts.
3.
Mount the front axle assembly to the end
of the bed with the corresponding bolt pat-
tern using M8-1.25 x 20 carriage bolts, 8mm
washers and lock nuts.
REAR SUPPORT ASSEMBLY & WHEELS
1.
Loosely assemble the rear axle support to the
bed using M8-1.25 x 20 carriage bolts, 8mm
washers and lock nuts.
2.
Slide the left and right rear axle braces onto
the rear axles and bolt the opposite ends of
the braces to the bed using M8-1.25 x 20 car-
riage bolts, 8mm washers and lock nuts. See
Figure 2
3.
Tighten the rear axle support.
4.
Slide a wheel spacer bushing, part 22, on
each axle.
5.
Slide a wheel onto each axle with the valve
stems to the outside and fasten using the
M12-1.75 acorn nuts, 12mm flat washers
and lock washers.
FOLDING SIDES
1.
Using the panel assembly pins, fasten the
hinges of the side panels to the bed, with the
side panel hinges on the outside.
2.
Fasten the hinges of the front panel to the
end with the front axle assembly using the
panel assembly pins.
3.
Fasten the hinges of the back panel to the
end with the rear axle support using the
panel assembly pins.
PULL HANDLE
1.
Slide the plastic coupling on to the pull
handle, making sure the holes are correctly
aligned.
2.
Place the pull handle and plastic coupling
into the yoke and insert the M8-1.25 x 80
slotted screw. Fasten using an 8mm washer
and lock nut.
Note—
The Folding Sides Garden Wagon comes
equipped with a tractor connector. Slide
the tractor connector over the handle of the
wagon and connect to the tractor hitch.
If you need additional help with this procedure,
call our service department at: (570) 546-9663.
