Grizzly G9743, Owner'S Manual, Page: 18 / 52

-16-
Model G9743 (Mfg. since 12/07)
Wheels and Feet
Components and Hardware Needed: Qty
Wheels ............................................................... 2
Axle ................................................................... 1
Cotter Pins 3 x 25 .............................................. 2
Flat Washers
5
⁄
8
" ................................................ 4
Hex Nut
1
⁄
2
"-12 ................................................... 2
Foot ................................................................... 2
To install the wheels and feet:
1. Insert the axle into the cabinet (Figure 9).
Figure 8. Handle installed.
Handle
Components and Hardware Needed: Qty
Handle ............................................................... 1
Hex Nut
5
⁄
16
"-18 ................................................. 4
Flat Washer
5
⁄
16
" ................................................. 8
Hex Bolt
5
⁄
16
"-18 x 1
1
⁄
2
" ....................................... 4
To install the handle:
Position the handle onto the end of the cabinet
as shown and fasten it in place with the four
hex bolts, eight flat washers, and four hex nuts
(
Figure 8).
Foot Locations
Handle
Figure 9. Installing wheel.
Axle
2. Position a
5 ⁄
8
" flat washer on each side of
each wheel and slide the wheel onto the axle
end.
3. Install the cotter pin into the end of the axle to
hold the wheel on.
4. Install the remaining wheel in the same man-
ner.
5. Thread on one
1 ⁄
2
"-12 hex nut onto each
foot.
6. At the handle-end of the cabinet (Figure 8),
thread each foot into the cabinet and tighten
the hex nuts to lock the feet into place.