-4-
To install the hub adapter to the outboard
spindle:
1. Remove the hub adapter from the draw tube
assembly and unscrew the setscrews until
the ends are flush with the outer edge of the
hub.
2. Thread the hub adapter completely into the
outboard end of the lathe spindle. Secure the
hub adapter to the spindle by tightening the
setscrews shown in
Figure 5
.
Figure 3. Replacement mounting
stud installed.
Figure 2. Mounting stud removal.
Hub Adapter
Pivot Connector
Figure 4. Installing the pivot connector.
3. Replace the lathe cover and secure the bot-
tom knob
.
2. Install the replacement mounting stud as
shown in
Figure 3.
This pivot will allow the locking yoke to be
secured to the lathe while providing a range of
motion to engage and disengage the locking
mechanism. The pivot connector should be
secured tightly to the stud and the pivot pin
should be in a horizontal position, allowing the
pivot to move up and down.
To install the pivot connector:
Remove the pivoting rod connector from the draw
tube assembly and thread it onto the replacement
stud as shown in
Figure 4. Make sure you have
replaced the lathe cover!
Mounting Studs
To remove the mounting stud and install the
replacement stud:
1. Remove the upper mounting stud as shown
in
Figure 2.
