-10-
g1028z/g1029z dust Collector
figure 1. recommended plug types.
5-20 plug & outlet
for 110v
6-15 plug & outlet
for 220v
SECTiON 2: CiRCUiT REQUiREMENTS
full Load amperage Draw
this machine draws the following amps under
maximum load:
amp draw at 110v (prewired) ............... 18 amps
amp draw at 220v ................................. 9 amps
power Supply Circuit Requirements
you must connect your machine to a grounded
circuit that is rated for the amperage given below.
never replace a circuit breaker on an existing cir-
cuit with one of higher amperage without consult-
ing a qualified electrician to ensure compliance
with wiring codes.
Serious personal injury could occur if you
connect the machine to power before com-
pleting the setup process. DO NOT connect
the machine to the power until instructed
later in this manual.
Electrocution or fire could
result if machine is not
grounded and installed in
compliance with electrical
codes. Compliance MUST
be verified by a qualified
electrician!
NOTICE
The Model G1028Z is prewired for 110v. if
you plan to operate the machine at 220v,
the motor must be rewired (see page 31).
if you are unsure about the wiring codes in
your area or you plan to connect your machine
to a shared circuit, consult a qualified electri-
cian.
minimum Circuit size (110v) ..................20 amps
minimum Circuit size (220v) ................. 15 amps
power Connection Device
the type of plug required to connect your machine
to power depends on the type of service you cur-
rently have or plan to install. We recommend
using one of the plugs shown in
figure 1.
Extension Cords
using extension cords may reduce the life of the
motor. instead, place the machine near a power
source. if you must use an extension cord:
•
For 110v, use at least a 12 gauge cord that
does not exceed 50 feet in length.
•
For 220v, use at least a 14 gauge cord that
does not exceed 50 feet in length.
•
the extension cord must have a ground wire
and plug pin.
G1028Z
110/220v Operation
