-18-
Model G0923 (Mfd. Since 05/20)
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To complete a typical operation, the operator
does the following:
1. Creates or downloads 3D model.
2. Uses slicer software to prepare .GCODE file,
then loads file onto SD card.
3. Ensures build plate is clean and level.
4. Applies adhesive to build plate.
5. Preheats nozzle.
6. Loads filament into machine.
7. Starts print.
8.
Removes model from build plate when print is
complete.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To reduce risk of machine
damage and injury, read
this entire manual BEFORE
using machine.
Summary of Contents for G0923
Page 56: ......
