Grizzly G0811, Owner'S Manual

Page: 50 / 68

-48-
Model G0811 (Mfd. Since 02/16)
The Model G0811 has a blade brush to help keep
metal chips off the blade wheels. It will wear over
time and require re-adjustment when it no longer
contacts the blade.
Tool Needed Qty
Hex Wrench 4mm .............................................. 1
To adjust blade brush:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen button headstock cap screw shown in
Figure 69.
Blade Brush
Figure 69. Blade brush adjustment location.
3. Slide blade brush bracket as needed so
blade extends approximately
1
⁄
8
" into bristles
of brush. Hold bracket in position, then re-
tighten button head cap screw.
Button
Head Cap
Screw
Limit Switch Stop
Bolt
The limit switch stop bolt will need to be adjusted
if the machine does not turn
OFF after it com-
pletes a cut.
To adjust limit switch stop bolt:
1. DISCONNECT MACHINE FROM POWER!
2. Lift headstock, then adjust feed rate dial as
needed, and lower headstock.
3. Listen for click from limit switch (see Figure
70) when headstock reaches bottom of its
travel. If switch does not click, loosen jam nut
(see
Figure 70), slightly adjust stop bolt, and
repeat until satisfactory.
4. Tighten jam nut (see Figure 70) against base
to prevent stop bolt from loosening during
use.
Tools Needed Qty
Open-End Wrench 14mm .................................. 1
Open-End Wrench 17mm .................................. 1
Figure 70. Limit switch stop bolt and jam nut
location.
Jam Nut
Blade Brush
Stop Bolt
Limit Switch